Loading...
| How to install |
|---|
 |
01
Attachment of Box
A) Put the box and tighten with screws. · Make sure that the inclined side of the latch bolt faces in the direction of the door closing. · Screw sizes: 3/16 to 24 (iron doors) |
|---|
|
02
Removal of adhesion plate
A) Remove the adhesion plate attached to the handle of the inner door by turning it counterclockwise while holding the body. |
 |
|---|
 |
03
Installation of outer handle
A) Take out the key. (Note: the key may not come out when stalling with the key plugged) B) Fit the key into the groove of the square rod and the square hole and push it to fit the protrusion. C) Push the pillar into the pillar hole. D) Put the handle shaft into the shaft hole. |
|---|
| 04 Fastening with adhesion plate Place the plastic bushing and the adhesion plate inside the door and tighten it with the adhesive screw. After fastening the screw, check whether the dead bolt works properly with the key. Check the operation of the latch bolt with the handle. |  |
|---|
 |
05
Fixing the inner handle
A) While pushing the square rod into the square hole B) Align the handle shaft with the hole of the shaft, and tighten the screw hard to the right by using the fastener. |
|---|
| 06 Fixing the receiving plate After putting in the receiving plate box, place the receiving plate and tighten the screws with a screwdriver. |  |
|---|
| Integral Lock | Lever Type Lock for front doors |
Lever Type Lock for beds |
|
|---|---|---|---|
| Lever Type Lock for bathrooms |
Cylindrical Lock for wooden door |
31LC series stainless steel |
|
| How to install |
|---|
|
|---|
|
01Attachment of Box
A) Put the box and tighten with screws. · Make sure that the inclined side of the latch bolt faces in the direction of the door closing. · Screw sizes: 3/16 to 24 (iron doors) |
|
|---|
| 02Removal of adhesion plate A) Remove the adhesion plate attached to the handle of the inner door by turning it counterclockwise while holding the body. |
|
|---|
|
03
Installation of outer handle
A) Take out the key. (Note: the key may not come out when stalling with the key plugged) B) Fit the key into the groove of the square rod and the square hole and push it to fit the protrusion. C) Push the pillar into the pillar hole. D) Put the handle shaft into the shaft hole. |
|
|---|
| 04 Fastening with adhesion plate Place the plastic bushing and the adhesion plate inside the door and tighten it with the adhesive screw. After fastening the screw, check whether the dead bolt works properly with the key. Check the operation of the latch bolt with the handle. |
|
|---|
|
05
Fixing the inner handle
A) While pushing the square rod into the square hole B) Align the handle shaft with the hole of the shaft, and tighten the screw hard to the right by using the fastener. |
|
|---|
| 06 Fixing the receiving plate After putting in the receiving plate box, place the receiving plate and tighten the screws with a screwdriver. |
